 Fast, Easy, Accurate 5-minute Application for Golf Grips Self-Adhesive Sheet Golf Grip Build-Up Material |
||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| CLICK
ON THE PHOTOS ABOVE TO VIEW LARGER IMAGES |
||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| Step-by-Step
Application of Add-On Self-Adhesive Sheets for Golf Grips These steps apply to building-up grips on golf club grips only. Add-On provides a fast, easy, accurate way of building-up the grips of clubs to personally fit the hands of the athlete. Add-On will result in a build-up job that is uniform in thickness, enhances the feel of the grip and is durable enough to withstand a wide array competitive sports situations and environments. The entire process can take as little as five minutes to complete. |
||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||
| • | Before
you begin: Determine which thickness Add-On (GO16 HALF + 1/32")
or (GO31 FULL +1/16") you will need, then proceed with the following
steps: Note: Steel shaft: If the golf shaft has a grip on it already, remove grip using a hook blade grip knife & a utility knife to remove the grip tape. Note: Graphite shaft: Remove grip using a hook blade grip knife, but do not scrape tape from a graphite shaft using a knife. Warm the old tape using a heat gun for 1 to 2 minutes, then peel tape from shaft. Now, clean shaft with solvent. |
|||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| • | Step One: Align the 2" wide end of the Add-On Self-Adhesive Sheet to the butt end of the golf shaft & parallel to the length of the shaft. Now, using only your hands, press-wrap it completely around the golf club shaft. | |||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| • | Step Two: Using a utility knife, trim any excess overlapping Add-On material along the 10" mating seam. | |||||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||||
| • | Step Three: Apply double-face tape around the built-up golf club shaft. | |||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| • | Step Four: Remove paper backing to expose adhesive. | |||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||
| • | Step Five: Apply grip solvent (or lighter fluid) to double-face tape & a small amount inside the grip, then slip grip onto shaft & properly align with club face. Allow gripped club to set for 15-minutes or more before swinging and hitting balls with the club. | |||||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||||
| IMPORTANT: The
use of a heat gun to apply our “Original” Add-On Self-Adhesive
Sheets is NOT REQUIRED and should not
be used. Use the Online Order Form or Printable Order Form to order in packs of (12) sheets. To Order Add-On, contact our Authorized Add-On Distributors |
||||||||||||||||||||||||||||||
