|
“Original” Add-On Self-Adhesive
Sheets
The “Original” Add-On
Self-Adhesive Sheets are made
of a pliable, polyester, waxy resin material that will conform
to any shape surface while maintaining a uniform thickness
throughout. Add-On Self-Adhesive Sheets can be applied over
itself to produce even thicker build-ups if necessary.
The application of our Add-On “Original”
Self-Adhesive Sheet takes less than 5-minutes using only your
hands and a utility knife to trim any overlap material. Refer
to the Illustrated Step-by-Step Application Instructions
for details.
IMPORTANT:
The use of a heat gun to apply our “Original” Add-On
Self-Adhesive Sheets is NOT REQUIRED
and should not be used.
“New” Add-On Heat-Shrink
Tubes
The “New!” Add-On
Heat-Shrink Tubes are made of a durable vinyl material
that will shrink to a racquet handle while maintaining a uniform
thickness throughout. An Add-On Heat-Shrink Tube can be applied
over itself to produce even thicker build-ups if necessary.
The application of our Add-On Heat-Shrink
Tube takes around 5-minutes using a shop-type heat gun (or
a good quality hair dryer) and a utility knife to trim any
excess material from the butt cap of the racquet. Refer to
the Illustrated Step-by-Step Application Instructions
for details.
IMPORTANT:
Over time, if stored in a warm environment (+70-degrees F),
tubes could shrink approximately 1/4" in length before
use. Store in a cool place.
To build-up grips on racquetball,
squash and badminton racquets,only use the Add-On “Original”
Self-Adhesive Sheets.
|
